Full automatic sole cleaning machine:



The cleaning and drainage system and the power supply are installed. After opening the power supply, the inlet and outlet pipe switches are opened, and the automatic sole cleaning machine can be used.



1, brush shoe sole: the person passes the radar inductor at the entrance of the cleaning machine, the equipment will automatically induce the click and run, the belt type brush will drive the water that enters the water trough through the inlet pipe, and the person can walk normally (if the equipment purchased is small, please stand on the clean equipment plane for three or four seconds, " It will clean not thoroughly, such as the purchase of a large size of the cleaning equipment, the normal speed of walking) in the automatic brush machine brush plane, brush and water can start to clean the sole.



2, dry suction area dry sole residual water: after the brush shoe area, the personnel pass through the strong water absorption area, water absorbent mat will dry the sole of the sole of the shoe, so that the sole is clean and clean, entering the room and not entering the water.



Note: because of the number of people, the size of the product is different, not better cleaning and dry effect, please spare the strong absorbent pad for replacement. If the dry area is especially small, please add the strong water absorbent pad of enough size according to its own situation.
 
3, manual mode and automatic mode switching: HRSC series full automatic sole cleaner for hand, can be fully automatic injection drainage, also can manual injection and drainage, factory is set according to customer needs. If the automatic and manual mode is needed in use, the controller can be opened according to the identification on the device, the button 5 (automatic mode) and the 6 (manual mode) can switch the manual mode and automatic mode, and the corresponding 5 and 6 light is the corresponding mode switching successfully.

4. The injection and drainage of the sole cleaning machine:



1. Automatic mode: under the condition of docking well into the drain pipe, it can be automatically injected and drained.

Manual mode: unconditional access to drain pipe, manual water and manual drainage. When adding water, please open the filter plate and add water. Please add water according to the water level control line on the inner side of the sewage tank (not more than the red warning line). Note: if the water level is not enough, the equipment may not operate.

The drainage of the sole cleaning machine: open the dry area net plate, the inside of the reservoir have the manual discharge switch button, press the button, start the drainage, after the sewage tank sewage is discharged, please press the switch button again, reset the cleaning equipment to restore the original working mode.